GREEN PICTURE WITH RETRACE LINES?BASIC SOLUTION WITH PICTURES!!!

Most of the CRT tv's encounter this problem and this tutorial will show you on how to solve this problem. But before doing this perform checking your safety:

First make sure that you unplug the TV before doing this. Properly place it to avoid falling the appliances and create more damage. Keep away from children and anything that can cause treat of life. Remember, electric shock can hurt you badly or even worst cost life. Here we go: Uncover the TV and locate the CRT circuit.

Check if there is cold solder by looking at the soldered parts. In my case, a lot of cold solder so i have to fix it first by soldering it.

Basically, this is the very reason why CRT tv's having this problem. Make sure that these Resistors and Transistors are soldered properly.

After soldering it, try to power up to know if the problem was fix. If it was fix, then congratulations but if not, just replace the three transistor and three resistor shown in the picture. These parts are not costly so better replace it. If the problem still exist, then it's time to bring your TV to the nearest shop for further testing.

Comments

EASIEST WAY ON HOW TO TEST A REMOTE CONTROL WITH PICTURES

Most of the gadgets now are widely using remote control. Remote control is a component of an electronic device used to operate the device wirelessly from a distance and used to provide more convenient and make life easier using the appliances in our homes.But like other gadget sometimes these can cause that our appliances not to function.Your in doubt if it is the appliances or the remote control wasn't functioning. One way to clear your doubt is to check first the remote control. Here is the easiest way to check the remote control: First, make sure that the battery of the remote is ok and if it was used quite a long time, then it is recommended to replace the battery immediately to minimize the time in checking. Make sure that there's no rust between the battery terminal because it sometimes minimizes the voltage that supplied to power up the remote. If these were already done and you are sure that no battery issue of the remote is affecting to power up, then let...

How to SET UP WIFI password of POCKET WIFI-with PICTURES!!!

1. First remove the cover and battery then look for the username and password and the IP address. 2. Open your browser and enter the IP address. 3. Input the user name and password as shown at the back of the pocket wifi. 4. Click on settings. 5. Then click on these two options you want and create password you want.;) Please like and follow..;)

Easy Solutions

Search This Blog