EASIEST WAY ON HOW TO TEST A REMOTE CONTROL WITH PICTURES
Most of the gadgets now are widely using remote control.
Remote control is a component of an electronic device used to operate the device
wirelessly from a distance and used to provide more convenient and make
life easier using the appliances in our homes.But like other gadget
sometimes these can cause that our appliances not to function.Your in
doubt if it is the appliances or the remote control wasn't functioning.
One way to clear your doubt is to check first the remote control.
Here is the easiest way to check the remote control:
First, make sure that the battery of the remote is ok and if it was used
quite a long time, then it is recommended to replace the battery immediately to minimize
the time in checking.
Make sure that there's no rust between the battery terminal because it sometimes
minimizes the voltage that supplied to power up the remote.
If these were already done and you are sure that no battery issue of the
remote is affecting to power up, then lets do this trick:
Here we go:
Using your camera phone, look at the remote then press and hold any of the button and see
if there is light visible of the IR emitter as shown in the picture.You cannot see this light
with your eyes, but by using a digital camera, cell phone camera, or camcorder in camera mode
you can see the signal.
If all the buttons make the
IR emitter to give light, therefore your remote control is ok.
also if some of the buttons can trigger the light and some are not, therefore you still
need to buy a new remote control. Buying a new remote control is not costly than bringing
your appliances to electronics shop only to find out that the remote control was malfunctioning.
1. First remove the cover and battery then look for the username and password and the IP address. 2. Open your browser and enter the IP address. 3. Input the user name and password as shown at the back of the pocket wifi. 4. Click on settings. 5. Then click on these two options you want and create password you want.;) Please like and follow..;)
Most of the CRT tv's encounter this problem and this tutorial will show you on how to solve this problem. But before doing this perform checking your safety: First make sure that you unplug the TV before doing this. Properly place it to avoid falling the appliances and create more damage. Keep away from children and anything that can cause treat of life. Remember, electric shock can hurt you badly or even worst cost life. Here we go: Uncover the TV and locate the CRT circuit. Check if there is cold solder by looking at the soldered parts. In my case, a lot of cold solder so i have to fix it first by soldering it. Basically, this is the very reason why CRT tv's having this problem. Make sure that these Resistors and Transistors are soldered properly. After soldering it, try to power up to know if the problem was fix. If it was fix, then congratulations but if not, just replace the three transistor and three resistor shown in the picture. These parts are ...
Comments
Post a Comment